Name: Liam. Ford Model: MK2 Focus. Ford Year: 2005. UK/Ireland Location: Somerset. Posted September 1, 2015. Hey, I recently got a 1.8 Diesel MK2 Focus (Titanium) as a cheap run around however ran into some issues with it last week 5 days after the warranty ran out :|. I used the car the weekend before and it appeared to be working fine Sounds like an immobiliser fault, likely to be caused by bad soldering in the dash cluster (speedo clocks), fairly common issue on the Mk2 although less frequent on the Mk2.5. If you have a Windows laptop I'd recommend Forscan over any generic OBD scanner. After running at 3000rpm for 10 mins and left to idle, the coolant is pretty much boiling and can’t be seen in the expansion vessel. This implies that the level of coolant is low and it is only visible in the vessel due to an abundance of air trapped, given that water doesn’t compress and there’s only so much bulging of rubber pipes to be had. Ford Year: 2007. UK/Ireland Location: Cumbria. Posted March 26, 2013. Help required, I have a 2007 Focus 1.8 tdci. The car started on Saturday morning then cut out. An Engine Systems Fault message came up on the dash board. I continued to try and start the car without any success. Ford Focus Mk2 Tdci 1.8 problemi ECU i senzor radilice. Pozdrav ekipi, ovo je moj prvi post, s obzirom da se sa mojim fordom borim već nekih mjesec i pol probat ću tu prokomentirati sa vama situaciju. Prelistao sam razne teme da ne dupliciram ali nisam našao baš istu situaciju. Radi se o ford focusu iz naslova, 2007 godište, ima oko 225. Thanks for the reply. I haven't had any issues with starting the engine, just that it's in limp mode. I have just realised that I have been using forscan in demo mode . Insurance. Support. Hi, We recently bought a 2008 ford transit tipper 2.4TDCI, we've found once it warms up it internittently starts feeling like its going to cut out when idling, you have to rev the engine to keep it going. However, sonetimes it will run smoothly for a few hours and then will the problem randomly s When driving the car, the "engine systems fault" warning comes on, accompanied by the little red warning lamp. It normally happens when putting the engine under load in 5th gear - i.e trying to overtake but I can also cause the error show up by flooring the accelerator pedal in the lower gears too (not something I'm in the habit of doing - just t28GcW0.